Pelagic Crimping Pliers

$110.00 $89.00

YOU SAVE: $21.00 (19%)
  • Product Code: 6HC

  • Manufacturer: Pelagic Spearfishing

  • Quantity

Add to Wishlist

Pelagic Crimping Pliers

All spearos have the need to properly rig each shaft with a strong and appropriate monofilament line of the correct thickness and breaking strength that reduces friction compared to similar thickness braids and avoids the possibility of entanglement. A crimped monofilament loop also reduces friction in the water compared to a larger knot and the possibility of entanglement in the front of the gun is greatly eliminated.


Depending on one's preference the shooting line between the gun and spear shaft or the shaft and reel is typically between 1.4 - 2.0mm. Monofilament is not easily made into knots over a certain thickness so the most efficient and strong way to join loops is by using sleeves of the appropriate length. Copper sleeves and some alloy sleeves are double shotgun barrel shaped while some are single hole but regardless of the type the Pelagic crimping tool ensures that when used with the correct setting/sleeve the crimped monofilament is small and strong.


    • Includes 1 x set of Pelagic pliers
    • Die sizes are 0.1 - 0.5 / 0.5 - 1.0 / 1.0 - 2.0 / 2.0 - 2.2 mm
    • Built in side cutter for mono/cable
    • Rubber handles for maximum grip when crimping
    • Pelagic Crimping Pliers can be used with either mini aluminum or copper sleeves

    Pelagic Product Warranty

    Pelagic Spearfishing Supplies offers warranty for all products purchased from an Authorised Dealer in Australia. Warranty coverage for the above mentioned products will only apply to products accompanied by proof of purchase and photos where applicable from an Authorised Australian Dealer. Pelagic Spearfishing Supplies warrants that it will fix, repair or replace any defective product described above at no cost to the consumer save the expense of the consumer returning any defective product to the nearest Authorised Australian Dealer. Products may also be returned directly to Pelagic Spearfishing Supplies. After service, the product will then be returned to the Authorised Dealer for collection, or to the consumer at no cost, with the balance of the applicable warranty intact. Please note that this warranty is offered in addition to any other rights that the consumer may have under Australian Consumer law (ACL). Additionally, failure to register the product does not diminish the consumers warranty rights. If you did not purchase your product from an Authorised Australian Dealer, a service charge will be levied if service is required. You can alternatively return it to the original point of purchase for service.

    This product hasn't been reviewed yet. Write a review